How to Install a Water Pump in a Saturn Ion

Submit Your Tip

How to Install a Water Pump in a Saturn Ion – This is a place for the community to provide tips and advice on How to Install a Water Pump in a Saturn Ion. This topic was created by Angela Liu and the tips are provided by the community. The tips you add here can be your own or referred from another site. The best tips are then ranked at the top when up-voted by members of the community.

Tip 1 - How to Replace the windshield washer pump in a Saturn car

Published: 9 years, 5 month(s) ago | Submitted by Martin Krejci | permalink

This video demonstrates how to replace the windshield washer pump in a Saturn S series car. Remove the reservoir by unscrewing the bolt and lift the reservoir and slide it back to take it off the mount. Disconnect the electrical connector by squeezing the clips and pull the connector off. Next remove the hose, making sure to cover the opening with the winger to prevent loss of fluid from the reservoir. Drain the fluid from the reservoir as shown. Get the pump off the reservoir by tapping the ends out as shown. Reuse parts if needed and insert the new pump as shown. Reattach the hose and

For further reading: http://diy-auto-repair.wonderhowto.com/how-to/replace-windshield-washer-pump-saturn-car-318110/ ^[1]

Tip 2 - GM 2.2 Ecotec Water Pump Job Made Easy J-43651 | Tech Articles

Published: 9 years, 5 month(s) ago | Submitted by Ed Jackowiak | permalink

How to tech article about a specialty tool for changing water pumps on the Ecotec engine, using this tool saves money & down time.
Tags: j-43651 ecotec waterpump water pump vs4769 sealy kent moore spx

For further reading: http://www.denlorstools.com/home/dt1/page_9822/gm_2.2_ecotec_water_pump_job_made_easy_j-43651.html ^[2]

Tip 3 - How to Install a Water Pump in a Saturn | eHow

Published: 9 years, 5 month(s) ago | Submitted by Thor Fongaard | permalink

The water pump on a Saturn is located on the front passenger side of the car halfway between the bottom and top of the engine. The easiest way to access the water pump for removal and installation is through the wheel well on the front passenger side of the car. If you've never done this before, set aside about an hour or two for the job.

For further reading: http://www.ehow.com/how_6674985_install-water-pump-saturn.html ^[3]

Tip 4 - Specs to Make Water Pump Holding Tool for 2003 Saturn Ion

Published: 9 years, 5 month(s) ago | Submitted by Sheron Brown | permalink

The Haynes manual shows a homemade water pump holding tool and since i cant wait for one to be shipped from catalog no one else carries iti need the...

For further reading: http://www.2carpros.com/questions/2003-saturn-ion-specs-make-water-pump-holding-tool ^[4]